I believe any of the open source software is PC only as well. Good luck if you choose to attempt this, and either way, post whether you were successful or not. You would need to make sure you have the AP 2.0 as it has a USB cable. If your Mac is the Intel based version, I know you could load it with Windows and possibly run it then but I personally have never done this. Unfortunately, the Cobb AP only connects with a PC. It gives me about 80 more miles to a tank of gas. I use the fuel economy map when I know I will not be racing for a while. Also has some other maps that you might find useful. It comes with Stage 1 maps for 91 and 93 octane fuel, Stage 2 maps for 91 and 93 as well. The AP comes preloaded with maps on it, plus you can go to COBB's web site and DL other maps. the StreetTuner software allows for you to customize your engine settings. But you do not need the StreetTuner software to run an AP. Around $205 total a seperate cost from your AP purchase. A map file can also be located on your computer by right-clicking on a Map in the list and choosing "Open Map file location.Yes.Additional columns can also be displayed in the map search area by right-clicking on any of the columns, and selecting the desired columns to display.If changes to map files happen while Accessport Manager is running, press the Refresh button and the changes will be detected and loaded. These map details and search location are saved even when the software is closed, so searching the same location does not take a long time to load details next time the software is opened.Results will instantly be displayed, even while typing. Perform a text search by typing in the "Search." box or use the drop-down to filter by vehicle. All sub-folders and files will be indexed for searching, and all maps meeting the filter criteria will be displayed in the list. Click the Browse button by the Location box to choose the location to search.This search feature is primarily used by COBB ProTuners that have thousands of customer maps to search through. This will open a new area used for searching through the map descriptions, vendor names, map revisions, vehicle types, and more. Note: Very old V2 Accessport firmware may require selecting "Re-connect" from the main menu on the Accessport itself.Īccessport Manager allows searching through the internal map details of a large number of maps, by clicking the "Search for Maps" button. If you would like to reconnect the Accessport to the computer, simply press "Connect" again. When you're finished managing the files on your Accessport, press the "Eject AP" button to disconnect. It is strongly advised to update to new Accessport firmware whenever Accessport Manager notifies that it is available, because we are constantly improving our products! Accessport Manager will also automatically check for new firmware for your Accessport. Once plugged in, the Accessport will start up and be detected by Accessport Manager, as long as "Automatically connect to Accessport" is checked under Options. If using a different cable than was supplied with the Accessport, make sure it is data transfer capable and not simply a charging cable. The larger end of the USB cable goes to the computer and the smaller end of the USB cable goes to the Accessport. To update your Accessport with new maps and update firmware, use the supplied USB cable to connect the Accessport to your computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |